Share
Pin
Tweet
Send
Share
Send
The article gives a diagram of the ignition system, the fuel pump relay of the Audi 100 car with a description of the constituent parts. The article gives a diagram of the ignition system, the fuel pump relay of the Audi 100 car with a description of the constituent parts.
This diagram will help you figure out when repairing the ignition system on a car with your own hands. If not all the legend in the picture is intuitive, then go here to familiarize yourself with all the components.
Ignition circuit diagram, fuel pump relay
| G - sensor that shows the fuel level; | Р - spark plug tip; |
| G6 - electric car fuel pump; | Q - spark plug; |
| G40 - Hall sensor; | S13 - fuse on the relay board; |
| J17 - fuel pump relay; | S22 - fuse on the relay board; |
| N - Audi 100 ignition coil; | T10 - 10-pin connector (blue), located behind the dashboard; |
| N9 - a regulator that heats up the car motor; | T10d - 10-pin connector (yellow), located behind the dashboard; |
| N41 - ignition switch; | 83 - connection to "mass" 1 in the front wiring harness on the right; |
| О - ignition distributor; | 86 - ground connection 1 in the rear wiring harness. |
Audi
Share
Pin
Tweet
Send
Share
Send
